MINI PAK'R Error Code: E6

RFID Error

How to fix this error:

  • Press STOP/RESET. Wait for a RDY display. Operate the machine normally.
  • Firmly push on the end of the film roll to make sure it is fully inserted onto the roll holder. Press STOP/RESET. Wait for a RDY display. Operate the machine normally.
  • Rotate the roll of film by hand 90 degrees in either direction. Press STOP/RESET. Wait for a RDY display. Operate the machine normally. Repeat 2 or 3 times.
  • Load a different roll of film. Press STOP/RESET. Wait for the RDY display. Operate the machine normally.
  • If the problem persists, please call 1-888-MINIPKR (1-888-646-4757) for service.
Have more questions? Submit a request

Comments

  • Avatar
    Jim Moviel

    E6 errors are caused when the machine can not read the embedded chip that is in the roll of film (RFID Tag). The most likely cause is the chip in the roll of film, try a different roll of film first. The second most likely cause is the RFID tag is in a blind spot on the Mandrel (The gray round thing you put the film on) so manually rotating the film either way should move you out of the blind spot - you will know the machine is reading the RFID tag if the numbers on the display pop up and start to count up - after trying these steps, if the problem persists call 866-374-7877 and a Factory Trained Technical Support Specialist will help you fix the error or arrange to hqave you machine returned to FP repair center to get the machine repaired.

Please sign in to leave a comment.